SXTH Element
Designed specifically for the 2010–2024 Toyota 4Runner’s naturally aspirated 4.0-liter V6, the SXTH Element CPLT Intake delivers dyno-proven power gains with no tuning required. A massive dry-flow filter, magnetic airbox lid, and platform-specific Helmholtz resonator bring together increased airflow, easy maintenance, and a clean intake sound without the annoying resonance.
Our Dynojet comparison recorded 226.89 wheel horsepower with the CPLT Intake, compared with 216.31 wheel horsepower with the OEM intake. That’s an increase of 10.58 peak wheel horsepower, with additional power and torque gains visible through much of the upper RPM range.
Peak wheel torque increased from 241.61 to 251.29 lb-ft, a gain of 9.68 lb-ft between the recorded peaks.
The displayed graph focuses on the upper RPM range, excluding the initial throttle roll-in affected by the automatic transmission’s kickdown behavior. Results reflect the tested vehicle and conditions.
Our new dry-flow filter features a 6-inch inlet, paired with a smooth taper to the factory MAF sensor diameter. This design supports increased airflow while preserving compatibility with the factory calibration and OEM drivability.
The dry-flow filter uses the same filtration technology covered in our published air filter testing. Laboratory testing following ISO 5011 / SAE J726 standards demonstrated up to 99.52% filtration efficiency, with low initial restriction at a test airflow of 300 m³/h.
Read our Air Filter Efficiency Testing report for the testing details.
Our integrated Helmholtz resonator is developed specifically for the 4Runner’s 4.0-liter V6. It targets the unwanted resonance that can make aftermarket intakes intrusive, including the harsh pitch around 3,800–4,000 RPM under heavier throttle.
The result is a smooth, strong intake tone through redline, giving your V6 more character while keeping everyday driving comfortable.
Our signature magnetic airbox lid gives you quick access to the filter. Lift the cover to inspect or service the filter, then snap it back into place.
The CPLT Intake installs without vehicle modifications and retains the OEM attachments. Its MAF section matches the factory sensor diameter, allowing the system to work with the stock ECU calibration.
Vehicle: 2010–2024 Toyota 4Runner
Engine: Naturally aspirated 4.0-liter V6
Tuning required: No
Minimum of 12 Months
Always the correct parts
Your information is safe
We know our products
Toyota 4Runner
5th Gen
Picked up on the trail
Based on what you've been checking out...
